Invacare R121 ユーザーズマニュアル
INSTALLATION
21
Mounting the Battery Charger
NOTE: For this procedure, refer to FIGURE 2.5.
NOTE: Refer to your local regulations concerning proper mounting procedures.
1. Place the battery charger with mounting bracket on the wall at the desired position.
2. With a pencil, mark the middle hole position.
3. Measure down 6½ inches from the pencil mark and drill one mounting hole.
4. Install the bottom mounting screw until there is an approximate 1/8‐inch gap between
the screw head and the wall.
5. Install the battery charger with mounting bracket onto the bottom mounting screw.
6. Drill the remaining two mounting holes.
7. Install the two remaining mounting screws through the mounting bracket and into the
wall. Tighten securely.
8. Plug the battery charger into the wall electrical outlet.
9. Verify that ON is illuminated.
FIGURE 2.5 Mounting the Battery Charger
Mounting Bracket
Mounting
Screws
Battery Charger
with Mounting
Bracket
Bottom Mounting Screw