Regency Wraps F33 사용자 설명서

Regency

F33-3 Freestanding Gas Stove

REMOVING VALVE ASSEMBLY

1) Shut off gas supply.

2) If optional fan is installed, disconnect power source to stove.

3) Remove access panel.
a) Front panel on pedestal model. See diagram 1.
b) Panel from bottom of leg shield. See diagram 2.

Note:

Access panel only has to be loosened to be taken out.

Diagram 1

Diagram 2

AERATION ADJUSTMENT

The burner aeration is factory set. Adjustment may be needed due to the
local gas supply or altitude. As a general rule if the ﬂ ame is too yellow
open up the air shutter, if it is too blue close the air shutter.

LPG

wide

open

Note:

This adjustment only to be made by an authorised

person.

PILOT ADJUSTMENT

Periodically check the pilot ﬂ ames. Correct ﬂ ame pattern has three
strong blue ﬂ ames: 1 ﬂ owing around the thermopile, 1 around the
thermocouple and 1 ﬂ owing across the burner (it does not have
to be touching the burner).

Note:

If you have an incorrect ﬂ ame pattern, contact your

Regency

dealer for further instructions.

MAINTENANCE

Incorrect ﬂ ame pattern will have small, probably yellow ﬂ ames,
not coming into proper contact with the rear burner or thermopile
or thermocouple.

Top View of pilot ﬂ ame

THERMOPILE/THERMOCOUPLE

REPLACEMENT

1) Loosen the thermocouple or thermopile with a 9mm spanner at

bracket.

2) Disconnect thermocouple by loosening nut from the valve with

a 9mm spanner. Disconnect thermopile by loosening 2 screws
marked TP on the valve.

3) Drop the thermocouple or thermopile down from the bracket and

pull it out of the unit.

4) Reinstall the new ones in reverse order.