Hitachi SJ300-037HFE 사용자 설명서
Using Intelligent Input Terminals
Oper
ations
a
nd Moni
tor
ing
4–28
Thermistor
Thermal
Protection
Thermal
Protection
Motors that are equipped with a thermistor can be protected from overheating. Input terminal
[TH] is dedicated to sense a thermistor resistance. The input can be set up (via B098 and B099)
to accept a wide variety of NTC or PTC type thermistors. Use this function to protect the motor
from overheating.
[TH] is dedicated to sense a thermistor resistance. The input can be set up (via B098 and B099)
to accept a wide variety of NTC or PTC type thermistors. Use this function to protect the motor
from overheating.
Opt.
Code
Symbol
Function Name
Input
State
Description
—
TH
Thermistor Thermal
Protection
Protection
Sensor
When a thermistor is connected between
to terminals [TH] and [CM1], the inverter
checks for over-temperature and will
cause a trip (E35) and turn OFF the output
to the motor
to terminals [TH] and [CM1], the inverter
checks for over-temperature and will
cause a trip (E35) and turn OFF the output
to the motor
Open
An open circuit in the thermistor causes a
trip, and the inverter turns OFF the output
trip, and the inverter turns OFF the output
Valid for
inputs:
inputs:
[TH] only
Required
settings:
settings:
B098 and B099
Notes:
• Be sure the thermistor is connected to termi-
• Be sure the thermistor is connected to termi-
nals [TH] and [CM1]. If the resistance is
above or below (depending on whether NTC
or PTC) the threshold the inverter will trip.
When the motor cools down enough, the
thermistor resistance will change enough to
permit you to clear the error. Press the STOP/
Reset key to clear the error.
above or below (depending on whether NTC
or PTC) the threshold the inverter will trip.
When the motor cools down enough, the
thermistor resistance will change enough to
permit you to clear the error. Press the STOP/
Reset key to clear the error.
5
3
1
7
6
4
2
8
FW
TH
PLC
CM1
P24
CM1
Example:
See I/O specs on page
TH
thermistor
Motor