Fujitsu P2X0-0202-01EN 사용자 설명서
9
P2X0-0202-01EN ETERNUSmgr User Guide -Introduction-
All Rights Reserved, Copyright © FUJITSU LIMITED 2007
2
Chapter 2
Setup
This chapter explains how to setup ETERNUSmgr.
Setup must be performed with administrator privilege.
Setup must be performed with administrator privilege.
2.1
Setup files
An ETERNUSmgr setup file is used to setup ETERNUSmgr to monitor a target device. The initial setup
files are generated automatically in the installation directory when ETERNUSmgr is installed. See the
"ETERNUS8000, ETERNUS4000, ETERNUS2000, ETERNUS6000, ETERNUS3000 ETERNUSmgr
Install Guide" of each OS for details of installing ETERNUSmgr.
The parameters in each setup file must be adjusted to match the target device. After making the necessary
settings, shutdown and re-start the ETERNUSmgr to enable the new settings. Refer to
files are generated automatically in the installation directory when ETERNUSmgr is installed. See the
"ETERNUS8000, ETERNUS4000, ETERNUS2000, ETERNUS6000, ETERNUS3000 ETERNUSmgr
Install Guide" of each OS for details of installing ETERNUSmgr.
The parameters in each setup file must be adjusted to match the target device. After making the necessary
settings, shutdown and re-start the ETERNUSmgr to enable the new settings. Refer to
for details on starting up and shutting down the system.
It is recommended that you make a backup of the current setup files before making any changes. Keep this
backup until you have verified that the new setup files operate normally.
backup until you have verified that the new setup files operate normally.
Caution:
You can edit only the setup file parameters described in this guide. Do not delete comments or
blank lines from any setup files, and do not add anything other than parameters. Failure to follow
these instructions may hinder performance and/or cause problems during future upgrades.
blank lines from any setup files, and do not add anything other than parameters. Failure to follow
these instructions may hinder performance and/or cause problems during future upgrades.
Setup file names must be in the following format:
If the file name is other than as specified above, ETERNUSmgr will not be able to detect the file.
The only place setup files should be saved is the installation directory. If a setup file is saved in another
directory, ETERNUSmgr will not be able to find it.
The only place setup files should be saved is the installation directory. If a setup file is saved in another
directory, ETERNUSmgr will not be able to find it.
The following setup file parameters must be set:
• Target Address (See
)
• Target Type (See
• Target Flag (See
• Alarm History Files Directory (See
The setup file parameters required will vary according to the operating system and target device type.
The following list shows parameter types in the setup file and setting items for each OS.
The following list shows parameter types in the setup file and setting items for each OS.
STX-.INI