Avaya CMC1 사용자 설명서

Use the following procedure and 

 to connect to the ESM equipment:

1. Install the TN2207 primary rate interface (PRI) circuit pack and the TN787F/G/H/J/K 

multimedia interface (MMI) circuit pack in the port carrier.

2. Record the circuit pack locations.

3. Connect the ESM Y-cable as shown.

1. Enter 

, and a list of the installed carriers, circuit packs, and 

ports appears.

2. Record the location (board number) of the new circuit packs and verify that all other 

required circuit packs (refer to 

) are present.

3. Enter 

, (where 

 is the location of the TN2207 PRI circuit pack 

recorded in step 2), and the DS1 circuit pack administration form appears.

4. Set the Name

:

 field to ESM DS1

5. Set the Bit Rate

: 

field to 2.048

6. Set the Line Coding

:

 field to hdb3