Siemens DataNET Hub (DNH) 사용자 설명서
64
• Data Communications Setup
2000585-001
System Status LEDs,
Continued
There are four Ethernet Link Status LEDs.
Link Active
LED is Green (on) when a link is established success-
fully between the Ethernet port and associated Ethernet
Hub or repeater.
fully between the Ethernet port and associated Ethernet
Hub or repeater.
If LED is OFF check for a bad cable, faulty wiring, or
loose connections.
loose connections.
Rx
Rx LED blinks when there is data reception on the
Ethernet port.
Ethernet port.
Tx
Tx LED blinks when the Ethernet port transmits a mes-
sage.
sage.
Collision
Collision LED blinks when there is a collision on the
Ethernet link. A collision is a normal event on an
Ethernet link and occurs when both sides of the link
attempt to transmit at the same time. Excessive colli-
sions indicate a problem with the network.
Ethernet link. A collision is a normal event on an
Ethernet link and occurs when both sides of the link
attempt to transmit at the same time. Excessive colli-
sions indicate a problem with the network.
Could be a cabling problem or bad network interface
board.
board.
The cross link status LED is red when no link is established between the
two DataNET Hub halves, and is green when a connection is detected.
Usually a red indication is caused by the absence of the cross link cable
or a faulty connection.
two DataNET Hub halves, and is green when a connection is detected.
Usually a red indication is caused by the absence of the cross link cable
or a faulty connection.
Ethernet Port LEDs
Cross Link Status
LED
LED