Canon lbp5970 사용자 가이드
![Canon](https://files.manualsbrain.com/attachments/4b6818c07b947b910f8cfb49338c2c63bdefaee1/common/fit/150/50/61ea34cb812b6780fe3b16f0b9221bd2f7635c65cee2473b66396d8b72cd/brand_logo.png)
44
Step
7
1
Press [Settings].
2
Select CONTROL MENU using [
] and [
], then
press [OK].
3
Select PANEL LANGUAGE using [
] and [
],
then press [OK].
4
Select the display language using [
] and [
],
then press [OK].
The display language is changed.
Turning the Printer OFF
Turn the printer OFF using the following procedure. The procedure for turning
the printer OFF is different between when a hard disk is used and when it is not
used.
IMPORTANT
•
When using the hard disk, be sure to turn the printer OFF as the
procedure for the protection of the hard disk. (See p. 44)
•
If the printer is connected to a network, make sure that other computers
are not sending print data to the printer before turning the printer OFF.
•
If you turn the printer OFF when the Job indicator is on, all the print data
remaining in the printer memory will be erased. If there is any necessary
print data remaining in the printer, wait until it is output, or press [Reset] in
the offline state and then select FORM FEED to output the data before
turning the printer OFF.
•
Do not turn the power OFF when the printer is in any of the following
status:
- During printing
- While the printer is running a self-diagnostic test immediately after
turning the power ON
- While a message informing you that the NVRAM is being initialized or
being written is displayed
- While <02 STARTING UP> or <02 CALIBRATING> is displayed
•
When you are using a hard disk, make sure that the HDD indicator is not
on. If you turn the printer OFF while the HDD indicator is on (while data is
being read from the hard disk or being written to the hard disk), the hard
disk may be damaged and disabled.
When Not Using a Hard Disk
When you are not using a hard disk, turn the printer OFF using the following
procedure.
procedure.
Settings
SETUP
CONTROL MENU →
OK
Settings
Utility
POWER SAVE MODE→
CONTROL MENU →
OK
Settings
Utility
PANEL LANGUAGE →
=ENGLISH →
OK
Settings
Utility
FRENCH →
=FRENCH →
PANNEAU LANGUES→