3com MSR 20-20 참조 매뉴얼

C

HAPTER

 149: NQA C

LIENT

 C

ONFIGURATION

 C

OMMANDS

password: Password used to log onto the FTP server, a string of 1 to 32 characters. 
It is case sensitive.

Use the password command to configure a password used to log onto the FTP 
server.

Use the undo password command to remove the configured password.

By default, no password is configured for logging onto the FTP server.

“username (FTP test type view)” on page 2287, “operation (FTP test type view)” 
on page 2276.

# Configure the password used for logging onto the FTP server as ftpuser.

<Sysname> system-view

[Sysname] nqa entry admin test

[Sysname-nqa-admin-test] type ftp

[Sysname-nqa-admin-test-ftp] password ftpuser 

probe count times

Any NQA test type view

times: Number of probes in a test, in the range 1 to 15.

Use the probe count command to configure the number of probes in a test.

Use the undo probe count command to restore the default.

By default, one probe is performed in a test.

■

For a TCP or DLSw test, one probe means one connection;

■

For a UDP-jitter test, the number of packets sent in one probe depends on the 
probe packet-number command;

■

For an FTP, HTTP or DHCP test, one probe means to carry out a corresponding 
function;

■

For an ICMP-echo or UDP-echo test, one packet is sent in one probe;

■

For an SNMP test, three packets are sent in a probe.

If the number of probes in a test is greater than 1, the system sends a second 
packet after it sends the first packet and receives a response packet. If the system 
does not receive a response packet, it waits for the test timer to expire before 
sending a second probe packet. The process is repeated until the specified probes 
are completed.