3com MSR 20-20 참조 매뉴얼
2642
C
HAPTER
174: D
IAL
P
LAN
C
ONFIGURATION
C
OMMANDS
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
[Sysname-voice-dial-entity10] select-stop
send-number
Syntax
send-number { digit-number | all | truncate }
undo send-number
View
POTS entity view
Parameter
digit-number: Number of digits (that are extracted from the end of a number) to
be sent, in the range of 0 to 31. It is not greater than the total number of digits of
the called number.
be sent, in the range of 0 to 31. It is not greater than the total number of digits of
the called number.
all: Sends all digits of a called number.
truncate: Sends a truncated called number.
Description
Use the send-number command to configure the number sending mode.
Use the undo send-number command to restore the default number sending
mode.
mode.
By default, the truncate mode is used.
Note that:
■
This command applies to only POTS voice entities. This command is used to
control how to send called numbers to PSTN. You can specify to send some
digits (defined by the digit-number argument from right to left) or all digits of
called numbers. You can also specify to send truncated called numbers, namely,
the ending digits of called numbers that match the dot.
control how to send called numbers to PSTN. You can specify to send some
digits (defined by the digit-number argument from right to left) or all digits of
called numbers. You can also specify to send truncated called numbers, namely,
the ending digits of called numbers that match the dot.
■
Here the dot represents the virtually matched digits. For details, refer to
“dot-match” on page 2628 and “match-template” on page 2599.
“dot-match” on page 2628 and “match-template” on page 2599.
Related command:
Example
# Configure voice entity 10 to send the last six digits of a called number.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
[Sysname-voice-dial-entity10] send-number 6