Cisco Cisco Aironet 350 Access Points 릴리즈 노트
4
Release Notes for Cisco Aironet 350, 1100, and 1200 Series Access Points for Cisco IOS Release 12.2(15)XR
OL-6047-01
New Features
Some Fields Not Updated During Upgrade to IOS Software
When you upgrade an access point to run Cisco IOS software, some fields that are reported in the console
messages during the upgrade are blank or are populated with zeros. However, blank or zero fields are
normal after a successful upgrade, because 350 and 1200 series access points do not support that
information. This example shows fields that might appear blank or populated with zeros:
messages during the upgrade are blank or are populated with zeros. However, blank or zero fields are
normal after a successful upgrade, because 350 and 1200 series access points do not support that
information. This example shows fields that might appear blank or populated with zeros:
32K bytes of flash-simulated non-volatile configuration memory.
Base Ethernet MAC Address: 00:05:9A:38:42:91
Part Number
:
0-0000-00
PCA Assembly Number
:
000-00000-00
PCA Revision Number
:
PCB Serial Number
:
Top Assembly Part Number
:
000-00000-00
Top Assembly Serial Number
:
Top Revision Number
:
Product/Model Number
:
AIR-AP352-IOS-UPGRD
New Features
This section lists new features in Cisco IOS Release 12.2(15)XR.
lists the features that are
supported on the devices that support this release.
IP-Based Wireless Domain Services
This feature enables the access point to be explicitly configured with the IP address of its WDS device.
This allows the access point to use a Cisco network infrastructure device running WDS from anywhere
in the network. For instructions on using this feature, refer to the “Configuring Access Points to use the
WDS Device” section on page 11-12 in the Cisco IOS Software Configuration Guide for Cisco Aironet
Access Points. Click this link to browse to the Cisco IOS Software Configuration Guide for Cisco Aironet
Access Points:
This allows the access point to use a Cisco network infrastructure device running WDS from anywhere
in the network. For instructions on using this feature, refer to the “Configuring Access Points to use the
WDS Device” section on page 11-12 in the Cisco IOS Software Configuration Guide for Cisco Aironet
Access Points. Click this link to browse to the Cisco IOS Software Configuration Guide for Cisco Aironet
Access Points:
Layer 3 Mobility Service through Fast Secure Roaming Tunnels
This feature allows an access point to segregate WLAN clients into different mobility groups. Once a
client is authenticated using its mobility group's security policy, all IP traffic from the client is
encapsulated using Generic Routing Encapsulation (GRE) and sent to a specific multipoint generic
routing encapsulation (mGRE) interface of a Cisco Structured Wireless-Aware Network (SWAN)
infrastructure device that supports mobility groups. A Layer 3 mobility service capable access point
provides clients within each mobility group with Layer 3 mobility when used with a Cisco SWAN
client is authenticated using its mobility group's security policy, all IP traffic from the client is
encapsulated using Generic Routing Encapsulation (GRE) and sent to a specific multipoint generic
routing encapsulation (mGRE) interface of a Cisco Structured Wireless-Aware Network (SWAN)
infrastructure device that supports mobility groups. A Layer 3 mobility service capable access point
provides clients within each mobility group with Layer 3 mobility when used with a Cisco SWAN
Table 1
New Features Introduced for Access Points in Cisco IOS Release 12.2(15)XR
Feature
350 Series
1100 Series
1200 Series
IP-Based Wireless Domain Services
–
x
x
Layer 3 Mobility Service via Fast Secure Roaming
Tunnels
Tunnels
–
x
x