Cisco Cisco WAP131 Wireless-N Dual Radio Access Point with PoE 설치 가이드

Because the factory default IP address configuration is DHCP, make sure 
that your DHCP server is running and can be reached. You may need to 
disconnect and reconnect the devices for them to discover their new IP 
addresses from the DHCP server. You can then query the DHCP server for 
the new IP address. See 

 for more information on how to find the DHCP address.

If the Cisco WAP131 does not receive a DHCP response (there is no DHCP 
server on your network) after 60 seconds, the Cisco WAP131 will fallback 
to the following default static IP address: 192.168.1.245 and a default mask 
of 255.255.255.0. To reach that IP address, be sure that your computer is 
on the 192.168.1.xxx network.

• If the Cisco WAP131 uses a power adapter, with the power on, use the 

POWER button to reboot the device. The POWER button only functions 
when the Cisco WAP131 uses a power adapter. 

• If the power supply is PoE, unplug your Ethernet connection for three 

seconds and plug it back in.

• With the power on, press the RESET button with an opened paper clip 

for less than 10 seconds, or until the lights go off. 

–

When all the lights go off, release the RESET button.

–

Release the RESET button as soon as the lights go off, or you will 
restore the Cisco WAP131 to factory default settings and lose your 
configurations.

• With the power on, press and hold the RESET button with an opened 

paper clip for more than 10 seconds.

–

All of the lights will go off.

–

Release the RESET button when the power light turns on.