Cisco Cisco WAP131 Wireless-N Dual Radio Access Point with PoE 설치 가이드

If it fails, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Request timed out.

Complete the Setup Wizard. The Wi-Fi radio on the Cisco WAP131 is 
turned off by default, and the Setup Wizard activates it. For users who do 
not want to use the Setup Wizard, log into the Cisco WAP131 using a 
Category 5e Ethernet cable, and activate the Wi-Fi radio manually. See the 
Administration Guide for details on activating the Wi-Fi radio.

Power up the switch and your computer if they are turned off.

Make sure that your PoE switch is powered on and the lights indicate that 
you have a link. See 

Verify that the devices on your network are not plugged into a switchable 
outlet.

Check the state of the indicator lights. See 

Check the Ethernet cable to ensure that it is firmly connected to your 
devices. Devices connected by the Ethernet cable can include the WAP 
devices, and routers, any switches, and your computer.

Verify that the connected switch has auto-negotiation enabled. The Cisco 
WAP131 and the switch need the same negotiation parameters set.

After a new firmware installation, if the POWER light is solid red, which 
indicates that the device fails to boot with both firmware images, contact 
system support; see 

.

The most likely cause of connectivity failure is an incorrect IP address. The 
Web browser may be pointing to the wrong IP address, or your computer 
may be configured with an IP address that is not in the same subnet as the 
Cisco WAP131.