Cisco Cisco WAP131 Wireless-N Dual Radio Access Point with PoE 설치 가이드

Follow the Setup Wizard instructions to finish the WAP device 
installation. The Setup Wizard turns on the Wi-Fi radio, which 
allows you to connect wirelessly. 

We strongly recommend that you use the Setup Wizard for the first 
installation. For more advanced configurations, see the 
Administration Guide. A link to the Administration Guide is found in 

.

Congratulations, you can now start using your Cisco WAP131.

In case of an error while installing, try the troubleshooting procedures 
described in this section. 

If you cannot display the configuration utility, you can test the ability of the 
computer to communicate with the Cisco WAP131 by using ping. To use 
ping on a computer running Windows: 

Verify that the Cisco WAP131 is powered on and the lights indicate 
the appropriate links.

Locate the Cisco WAP131’s IP address. While there are different 
ways to locate the IP address, this procedure uses Cisco FindIT.

a.

If you have previously downloaded Cisco FindIT, open Internet 

Explorer and launch Cisco FindIT. For more information on 
downloading Cisco FindIT, see 

.

b. In the Cisco FindIT display, place your mouse over the Cisco 

WAP131’s name. The Cisco WAP131’s IP address is displayed 
along with other device information.

Open a command window by choosing Start > Run and enter 
cmd.

At the command window prompt, enter ping and the Cisco 
WAP131’s IP address. In this example, we pinged 192.0.2.10. 

If successful, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128