Boss Audio Systems GT-100 사용자 설명서

JC CLEAN

This models the sound of the Roland JC-120 .

TW CLEAN

This models a Fender Twin Reverb .

CRUNCH

This is a crunch sound that can faithfully 

reproduce the nuances of picking .

COMBO DRIVE This is a combo amp sound that it suited to 

sixties-style British rock .

COMBO LEAD

This is a lead sound of a combo tube amp typical 

of the late ‘70s to ‘80s .

MS HiGAIN

This models the sound input to Input I on a 

Marshall 1959 .
This is a trebly sound suited to hard rock .

MODERN 

STACK

This original high-gain amp delivers thick lows 

and intense distortion while still preserving the 

sound’s clear definition .

CUSTOM CHAR -50–+50

+: For soloing
-: For backing

-50–+50

This controls the input sound’s low-frequency 

range and adjusts the amount of distortion in the 

low-frequency range .

CUSTOM EDGE -50–+50

This controls the input sound’s high-frequency 

range and adjusts the amount of distortion in the 

high-frequency range .

-50–+50

Adjusts the preamp section’s low-frequency tone .

PREAMP HIGH -50–+50

Adjusts the preamp section’s high-frequency 

tone .

5–15"

Selects the size of speaker .

x1, x2, x4, x8

Sets the number of speakers .

Selects the speaker cabinet type .

OPEN

This is an open-backed cabinet

CLOSE

This type of cabinet features an enclosed rear 

panel .

-10–+10

Adjusts the speaker section’s low-frequency tone .

-10–+10

Adjusts the speaker section’s high-frequency 

tone .

This adjusts the tone as a equalizer . A parametric type is adopted for the 

high-middle and low-middle range .

OFF, ON

Turns this effect on/off .

-20–+20 dB

Adjusts the low frequency range tone .

-20–+20 dB

Adjusts the high frequency range tone .

-20–+20 dB

Adjusts the overall volume level of the equalizer .

20 Hz–10 .0 kHz Specifies the center of the frequency range that 

will be adjusted by the LOW-MID GAIN .

0 .5–16

Adjusts the width of the area affected by the EQ 

centered at the LOW-MID FREQ . Higher values 

will narrow the area .

-20–+20 dB

Adjusts the low-middle frequency range tone .

20 Hz–10 .0 kHz Specifies the center of the frequency range that 

will be adjusted by the HIGH-MID GAIN .

0 .5–16

Adjusts the width of the area affected by the EQ 

centered at the HIGH-MID FREQ . Higher values 

will narrow the area .

-20–+20 dB

Adjusts the low-middle frequency range tone .

FLAT,  

20 Hz–800 Hz

This sets the frequency at which the low cut filter 

begins to take effect . When FLAT is selected, the 

low cut filter will have no effect .

630 Hz– 

12 .5 kHz, FLAT

This sets the frequency at which the high cut 

filter begins to take effect . When FLAT is selected, 

the high cut filter will have no effect .