Boss Audio Systems GT-100 사용자 설명서

With FX1 and FX2, you can select the effect to be used from the following . 

You can select the same effect for FX1 and FX2 .

OFF, ON

Turns this effect on/off .

Refer to FX1/FX2 TYPE

This is a list of the effects that can be selected for FX1/FX2 .

T . WAH
(Touch Wah)

You can produce a wah effect with the filter changing in response 

to the guitar level .

AUTO WAH
(Auto Wah)

This changes the filtering over a periodic cycle, providing an 

automatic wah effect .

You can control the wah effect in real time by adjusting the [EXP] 

pedal or the expression pedal connected to the SUB CTL 1, 2/SUB 

EXP jack .

ADV . COMP
(Advanced  

Compressor)

This is an effect that produces a long sustain by evening out the 

volume level of the input signal . You can also use it as a limiter to 

suppress only the sound peaks and prevent distortion .

The limiter attenuates loud input levels to prevent distortion .

This effect distorts the sound to create long sustain . 

GRAPHIC EQ
(Graphic 

Equalizer)

This adjusts the tone as a equalizer . You can adjust the sound 

quality in ten bands .

EQ
(Parametric 

Equalizer)

Adjusts the tonal quality . You can adjust the sound quality in four 

bands .

TONE MODIFY This changes the tone of the connected guitar .

GUITAR SIM
(Guitar 

Simulator)

Simulation of the characteristics of particular guitar components 

such as pickups and different guitar bodies allows you to switch 

among a number of different guitar types all while using a single 

guitar .

This produces a volume-swell effect (“violin-like” sound) .

This simulates a fretless guitar .

This is a synth sound that processes the guitar input signal .

SITAR SIM .
(Sitar 

Simulator)

This simulates the sound of the sitar .

This adds a note one octave lower, creating a richer sound .

PITCH SHIFTER This effect changes the pitch of the original sound (up or down) 

within a range of two octaves .

Harmonist is an effect where the amount of shifting is adjusted 

according to an analysis of the guitar input, allowing you to create 

harmony based on diatonic scales .

You can have sound played on the guitar be held continuously . 

This effect allows you to perform the melody in the upper registers 

while holding a note in the lower registers .

SOR
(Acoustic 

Processor)

This processor allows you to change the sound produced by the 

pickup on an acoustic electric guitar, creating a richer sound 

similar to that obtained with a microphone placed close to the 

guitar .

By adding varied-phase portions to the direct sound, the phaser 

effect gives a whooshing, swirling character to the sound .

The flanging effect gives a twisting, jet-airplane-like character to 

the sound .

Tremolo is an effect that creates a cyclic change in volume .

This produces an effect like the sound of a rotary speaker .

This models a Uni-Vibe .
Although this resembles a phaser effect, it also provides a unique 

undulation that you can’t get with a regular phaser .

With the volume level of the left and right sides alternately 

changing, when playing sound in stereo, you can get an effect that 

makes the guitar sound appear to fly back and forth between the 

speakers .

This consecutively interrupts the sound to create the impression 

that a rhythm backing phrase is being played .

This effect creates vibrato by slightly modulating the pitch .

This creates a bell-like sound by ring-modulating the guitar sound 

with the signal from the internal oscillator . The sound can be 

unmusical and lack distinctive pitches .

This can create human vowel-like sounds .

Frequency band division is employed to produce two different 

choruses, one for low frequencies and one for higher frequencies, 

for both the left and right channels (for a total of four) . This allows 

you to achieve a more natural chorus sound .

This is a delay with the maximum delay time of 1,000 ms . This 

effect is useful for making the sound fatter .