Elica ETT136SS 사용자 매뉴얼

•  If possible, disconnect and move freestanding or slide-in range 

 

from cabinet opening to provide easier access to rear wall.  

 

Otherwise put a thick, protective covering over countertop,  

 

cooktop or range to protect from damage and debris. Select a flat 

 

surface for assembling the unit. Cover that surface with a  

 

protective covering and place all canopy hood parts and hardware in it.

•  Determine and mark the centerline on the wall where the canopy 

 

hood will be installed.

•  Select a mounting height between a minimum of 18” (45.72 cm) 

 

and a suggested maximum of 24” (61 cm), above the cooking 

 

surface and the bottom of the range hood and mark a horizontal 

 

reference line on the wall.

•  Remove the wood support from the back of the range hood 

 

by loosening the 2 screws from the inside. Locate and level  

 

the top of the wood support 15

3

⁄

8

” (39.1 cm) above the marked 

 

horizontal line and centered on the vertical centerline. 

 

Using 2 - 6 x 80 mm screws, install wood support so that it is 

 

screwed into at least 2 vertical studs. 

Wood 

support

15

3

⁄

8

”

18”

to

24”

Centerline

of installation 

space

NOTE: The screws provided for mounting this hood must be 

fastened into solid wood, do not fasten into sheet rock only. 

 

Attach the full-width duct cover to the top of the range hood with the 

screws provided with duct covers. The duct cover must be attached to 

the top of the range hood before mounting the range hood to the wall. 

For information on ordering the optional duct cover, see “Optional 

Accessories” section. 

 

1.  Determine and make all necessary cuts in the wall for the vent 

 

system. Install the vent system before installing the range hood. 

 

See the “Venting Requirements” section.

2.  Determine the location where the power supply cable will be run 

 

through the wall.

3.  Drill a 1¼” (3.2 cm) hole at this location.

4.  Pull enough power supply cable through the wall to allow for easy 

 

connection to the terminal box.

5.  Install the 10” (25.4 cm) square x 10” (25.4 cm) round vent 

 

transition with damper to top of the range hood using  

 

4 - 3.5 x 9.5 mm screws. 

6.  Remove terminal box cover and set aside.

7.  Remove knockout from the top of the vent hood and install a UL 

 

listed or CSA approved ½” strain relief. See “Make Electrical 

 

Connection” section.

8.  Place the range hood near its mounting position and run the 

 

power supply cable through the strain relief into terminal box 

 

(enough to make connection).

9.  Tighten the strain relief screws. 

 

The hood attaches to the wall by the 2 mounting screws in the

wood support mounted to the wall.

1.  Remove metal grease filters. See the “Range Hood Care” 

 section. 

 

 

NOTE: Only for the ETT142SS model, remove the lateral 

 

panels as shown the picture below.