Siemens 125-3584T 사용자 설명서

Chapter 5 - Point Commander

Using the Point Commander Application

Siemens Industry, Inc.

125-3584T

Error Code

Situation

INVALID_DATATYPE

The data type of the value provided is incorrect

for the specified property.

VALUE_OUT_OF_RANGE

The value provided is outside the range of values

that the property can take on.

NO_SPACE_TO_WRITE_PROPERTY

There is not enough space to store the new

value.

DATATYPE_NOT_SUPPORTED

The data being written has a data type not

supported by the property.

Tips for Using the Point Commander Application



Points can be commanded from the Navigation pane or from an animated graphic.

See the

FINlite Graphics Tool

section for information on commanding a point from

a graphic.



You can only command points if you have been given Command or higher access

level to the point.
– Both analog and digital points can be commanded.
– Generally, only output points (AO, BO, and MSO) or virtual points (AV, BV,

MSV) can be commanded; however, AI and BI input points can be commanded

if taken out of service first.



If the same point is commanded from two different sessions, the command with the

higher priority will override. If the commands are made with the same priority, the

last command will override the earlier command.



Multi State Input Object (MSI) points are not supported on the FLN.



Use caution when moving the Commander window around the screen. If you move

it too far up the screen, you may not be able to access the title bar and move the

screen back down into view.

Using the Point Commander Application

Commanding Point Values

Commanding a point means using the Point Commander Application to manually

override the system program instructions for either an output point or a virtual input

point. Point commanding changes the command priority from NONE.

This procedure is only available to users with Command or higher access to points.