Lucent Technologies R5SI Manual Do Utilizador
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-982
M/T-PKT (Maintenance/Test Packet Bus Port)
10
Packet Bus Port Health Inquiry Test (#567)
This test verifies that the Packet Bus fault detection maintenance function of the
Maintenance/Test Packet Bus Port is functioning properly. This is done by having
the Maintenance/Test Packet Bus Port perform a self-test. If this self-test passes,
then the Packet Bus Port Health Inquiry Test passes. If the self-test fails, or the
SPE cannot communicate with the Maintenance/Test Packet Bus Port, then the
test fails.
Maintenance/Test Packet Bus Port is functioning properly. This is done by having
the Maintenance/Test Packet Bus Port perform a self-test. If this self-test passes,
then the Packet Bus Port Health Inquiry Test passes. If the self-test fails, or the
SPE cannot communicate with the Maintenance/Test Packet Bus Port, then the
test fails.
Table 10-284.
TEST #567 Packet Bus Port Health Inquiry Test
Error
Code
Test
Result
Description/ Recommendation
2000
ABORT
Response to the test request was not received within the
allowable time period.
allowable time period.
2100
ABORT
System resources necessary to run this test are not
available.
available.
2500
ABORT
An internal operation failed; the test could not be
completed.
completed.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
2059
FAIL
The Maintenance/Test Packet Bus Port has reported a
failure of the on-board self-test.
failure of the on-board self-test.
2060
FAIL
The Maintenance/Test Packet Bus Port has reported an
invalid state for the Packet Bus.
invalid state for the Packet Bus.
2061
FAIL
The SPE cannot communicate with the
Maintenance/Test Packet Bus Port, but is able to
communicate with the Maintenance/Test Circuit Pack.
Maintenance/Test Packet Bus Port, but is able to
communicate with the Maintenance/Test Circuit Pack.
1. Retry the command.
2. If the test continues to fail, replace the
Maintenance/Test circuit pack and retry the
command.
command.
3. If the test continues to fail, refer to PKT-BUS
Maintenance documentation to determine if the
M/T-PKT failure is being caused by a Packet Bus
fault.
M/T-PKT failure is being caused by a Packet Bus
fault.
PASS
The Maintenance/Test Packet Bus Port Packet Bus fault
detection capability is operating correctly.
detection capability is operating correctly.
Continued on next page