Copystar cs-1635 Guia Do Utilizador

Carry out the corresponding corrective procedure when any of the error 
messages shown in the table below are displayed.

There is no paper in the cassette. Load paper into the 
cassette as displayed in place of #.

Copies cannot be produced because there is no toner. 
Replace the toner container with a new one.

An original size that cannot be copied has been set. 
Check the original.
• The original was set in a vertical direction during the 

Book Border Erasure copying operation. Set the 
original horizontally.

• An irregular size original was set during the Border 

Erase or Combine mode operation.

• An original size other than Letter, Ledger, A3, A4R, 

A5R, B4 or B5R was set to make a split copy or a 2-
Sided Copy from a double-page spread original.

4-10, 4-12

A size that cannot be copied on both sides has been 
specified. 2-Sided copies cannot be taken when A6R, 
B6R, Postcard, Irregular Size or the paper size has not 
been specified. Specify a paper size that can be used.

Make a note of the C and the number (C# # # #). Turn 
the power switch OFF, unplug the power cord and 
contact your service representative.

–

The Document Processor is open. Close the Document 
Processor.

–

The left cover of the Document Processor is open. Close 
the left cover. Close the front cover.

–

The front cover of the copier is open. Close the front 
cover.

–

Add paper 

in cassette #.

Add toner.

Cannot copy

this paper size.

Cannot duplex

this paper size

Call service.

C####

Close document

processor.

Close document 

processor cover.

Close 

front cover.