Cisco Cisco Token Ring Port Adapters Guia Da Instalação
23
Cisco 7304 PCI Port Adapter Carrier Card Installation and Configuration Guide
OL-3067-02
Performing a Basic 7300-CC-PA Configuration
Performing a Basic 7300-CC-PA Configuration
After a 7300-CC-PA is installed, the system brings online only port adapter interfaces that match the
current configuration and were previously configured as up; all others require that you configure them
with the configure command.
current configuration and were previously configured as up; all others require that you configure them
with the configure command.
To configure the interfaces on the port adapters installed on your 7300-CC-PA, first enable the router as
described below.
described below.
Step 1
At the user-level EXEC prompt, enter the enable command. The EXEC prompts you for a
privileged-level password as follows:
privileged-level password as follows:
Router> enable
Password:
Step 2
Enter the password (the password is case sensitive). For security purposes, the password is not displayed.
When you enter the correct password, the system displays the privileged-level system prompt (#):
Router#
For a complete description of commands and configuration options available for your 7300-CC-PA, refer
to the configuration section of the specific port adapter installation and configuration guide and to the
appropriate Cisco IOS software configuration publications. (See the
to the configuration section of the specific port adapter installation and configuration guide and to the
appropriate Cisco IOS software configuration publications. (See the
.)
Checking the 7300-CC-PA Installation
This section describes the procedures you can use to verify your 7300-CC-PA installation, and includes
information on the following topics:
information on the following topics:
•
•
•
•
Verifying the Installation
This section describes how to verify the 7300-CC-PA installation by observing the7300-CC-PA LED
states, port adapter LED states, and the information displayed on your console terminal.
states, port adapter LED states, and the information displayed on your console terminal.
When the system has reinitialized all interfaces, the 7300-CC-PA STATUS LED should be on (green)
and the ENABLED LED on the port adapters should go on (green), depending on your connections and
configuration. The console screen also displays a message as the system discovers each interface during
its reinitialization.
and the ENABLED LED on the port adapters should go on (green), depending on your connections and
configuration. The console screen also displays a message as the system discovers each interface during
its reinitialization.
Note
A Fast Ethernet interface is used in the following examples for illustrative purposes.