Cisco Cisco Aironet 340 Ethernet Bridges Guia Do Utilizador

The Aironet 340 Series Bridge supports three connection types:

n 10Base2 (Thinnet)

n 10Base5 (Thicknet) AUI connector

n 10BaseT (Twisted Pair)

Í      To Attach 10Base2 (Thinnet) Cabling:

1.

Make sure the unit is powered off.

2.

Attach the Thinnet cabling to each end of a BNC T-connector, 

if applicable.

3.

Attach the T-connector to the 10Base2 BNC (Figure 1.4). If the unit 

is at the end of the Ethernet cable, a 50-Ohm terminator must be 
installed on the open end of the T-connector. 

Removing a terminator to install extra cable, or breaking an 

existing cable to install a T-connector, will cause a disruption in Ethernet 
traffic. Consult with your LAN administrator before you change any 
Ethernet cabling connections.

10Base2

10Base5

10BaseT