Cisco Headend System Release 2.7 Guia Da Instalação
Chapter 2 Installing the Software
32
4023373 Rev B
4 Click Start SpectroSERVER. The system begins restarting the Spectrum NMS.
When finished, the Status field at the bottom of the Spectrum Control Panel
changes to Running.
changes to Running.
5 Click Exit. A confirmation window opens.
6 Click OK. The confirmation and Spectrum Control Panel windows close.
7 Go to Restarting the DNCS (on page 32).
6 Click OK. The confirmation and Spectrum Control Panel windows close.
7 Go to Restarting the DNCS (on page 32).
Restarting the DNCS
1 On the DNCS, click the middle mouse button and select Administrative
Console. The DNCS Administrative Console window opens, along with the
DNCS Administrative Console Status window.
DNCS Administrative Console Status window.
2 On the DNCS Administrative Console Status window, click the Control (or
Monitor) button in the DNCS area. The DNCS Control (or Monitor) window
opens with a list of all the DNCS processes and their working states. A red state
indicates that a process is not running. At this point, all processes should show a
red state.
opens with a list of all the DNCS processes and their working states. A red state
indicates that a process is not running. At this point, all processes should show a
red state.
3 Click the middle mouse button and select DNCS Start. On the DNCS Control
window, all of the processes begin changing to a green state, which indicates that
they are running.
Note: It may take several minutes before all processes show a green state.
they are running.
Note: It may take several minutes before all processes show a green state.
4 Open an xterm window on the DNCS.
5 At the prompt, type dncsControl and press Enter. The DNCS Control window
5 At the prompt, type dncsControl and press Enter. The DNCS Control window
appears.
6 Type 2 to select Startup/Shutdown Single Element Group and press Enter. A
list appears of all the DNCS processes and shows their current working states
(running or stopped).
(running or stopped).
7 Press Enter to update the working states of the DNCS processes. Continue to
press Enter every few seconds until all processes show "run(2)" in the Current
State column.
Note: You will not see a status message while the processes are starting up.
When all processes show "run(2)" in the Current State column, follow the on-
screen instructions to close the DNCS Control window.
State column.
Note: You will not see a status message while the processes are starting up.
When all processes show "run(2)" in the Current State column, follow the on-
screen instructions to close the DNCS Control window.
8 Close any windows that may be open on the DNCS, except the xterm and the
DNCS Monitor windows.
9 Go to Restarting the SARA Server (on page 33).