Hewlett Packard Enterprise Company APEX0102 Manual Do Utilizador

| Installation Guide

The inclination of the AP (mounted to the mounting holder) can be adjusted up to +/-45 degrees by 

inserting the M6x20 screw (included in the package) into the different holes on the mounting holder. 
4. Use the cable tie to fasten the cables on the bracket.

The grounding must be completed before powering up the AP. The grounding wire should be #8 

AWG.
1. Peel the cover of one end of the grounding wire and place the bare grounding wire into the 

included copper lug, and press firmly with the crimping pliers.

2. Fasten the copper lug to the grounding hole on the AP with the included M4 x6 screw as shown in 

. 

To connect the Ethernet cable to the AP, perform the following steps using the cable glands that ships 

with your AP.

1. Slide the sealing nut over the cable (without the RJ45 connector attached to the end).
2. Slide the clamping ring over the cable.
3. Using a crimping tool, attach the shielded RJ45 connector to the end of the cable.
4. Remove the weatherproof cap on the Ethernet port. 

WARNING

Failure to use the included Ethernet cable glands can lead to connectivity and POE issues.

The cable is not included and must be purchased separately. Purchase a suitable UV-resistant, outdoor rated, 
CAT 5E or better RJ45 cable for use with the AP.

Sealing Nut

Clamping Ring

CAT 5E or Better Cable

Seals