ADC Telecommunications Inc. IRP1901A Manual Do Utilizador
InterReach picoBTS Installation Guide
Page 29
© 2008, ADC Telecommunications, Inc.
ADCP-77-061 • Issue A • 08/2008 • Chapter 3 - Commissioning and Configuration
It is necessary to change the default picoBTS Ethernet address to match your site-specific
network configuration. Use the following steps to modify the IP address and target name of the
picoBTS.
network configuration. Use the following steps to modify the IP address and target name of the
picoBTS.
5
Type the bootChange command to edit the boot parameters. The parameters will be
displayed one line at a time.
displayed one line at a time.
bootChange [ENTER]
'.' = clear field; '-' = go to previous field; ^D = quit
boot device : ata.0
processor number : 0
host name :
file name : hd0:/vxWorks
inet on ethernet (e) : 172.16.80.42:fffff000
inet on backplane (b):
host inet (h) :
gateway inet (g) :
user (u) : target
ftp password (pw) (blank = use rsh):
flags (f) : 0x0
target name (tn) : iwbox
startup script (s) : /hd0/iwvstart
other (o) : motfcc
value = 0 = 0x0
HD:iwbox-> _
Figure 3-4: Default Boot Parameters
'.' = clear field; '-' = go to previous field; ^D = quit
boot device : ata.0
processor number : 0
host name :
file name : hd0:/vxWorks
inet on ethernet (e) :
XXX.XXX.XXX.XXX:fffff000
inet on backplane (b):
host inet (h) :
gateway inet (g) :
host inet (h) :
gateway inet (g) :
YYY.YYY.YYY.YYY
user (u) :
ftp password (pw) (blank = use rsh):
flags (f) : 0x0
target name (tn) :
ftp password (pw) (blank = use rsh):
flags (f) : 0x0
target name (tn) :
TARGETNAME
startup script (s) : /hd0/iwvstart
other (o) : motfcc
other (o) : motfcc
value = 0 = 0x0
HD:iwbox-> _
Figure 3-5: Boot Parameters Requiring Changes
Preliminary