Monogram ZTD910SFSS Instrução De Instalação

*NOTE: When installing the warming drawer below a cooktop, a solid barrier must be
installed at least 1" from the lowest point of the bottom of cooktop burner box to the top 
of cutout. Use any solid material such as 1/4" thick plywood. Allow at least 1/4" air gap
between the barrier and the top of the warming drawer. See label on top of the warming
drawer for approved cooktop models.

The warming drawer may be installed beneath a cabinet
drawer. In this installation, a solid barrier should be installed
above the warming drawer to block access. Use any solid
material such as 1/4" thick plywood. Allow at least 1/4" 
air gap between the barrier and the top of the warming
drawer. Observe the 5" min. above the floor or 1" above 
the toekick minimum installation height.
NOTE: If you are installing in frameless cabinets, it may 
be necessary to install 1/2" wide cleats to accept drawer
mounting screws. See drawer to find exact locations 
of mounting screws.

Install two warming drawers in separate cutouts. 
Allow 2" min. between cutouts.

Install a Solid  Barrier

Below a Cooktop 

See Note

1-1/2" Cabinet Top

Side to Side Installation

36"

Countertop

Height

1" Min.*

2"

Min.

9-1/4"

9"

A

7"

25"

23-1/2" Min.

1/4" Air

Gap

Solid Barrier

Electrical Outlet 42" Max.

From Right Side

Install a Solid Barrier and

a 1/4" Air Gap Above

Warming Drawer

Electrical Outlet

16" Max. From

Left Side

Install 2x4 or 2x2 Anti-Tip Block

Against Rear Cabinet Wall 9"

From Floor to Bottom of Block

Electrical Outlet

Flush With Side of

Cabinet 7" Max.

• When installed, the front face of the drawer will 

be nearly flush with adjacent cabinetry doors.

• Drawer overlaps will conceal cut edges 

on all sides of the opening.

The rough opening for the drawer must be:
– Depth: 23-1/2" min. from inside back to front 

of cabinet frame.

– Width: 25-1/2" for 27" wide models, 

28-1/2" for 30" wide models.

– Height: 9-1/4".

• 5" min. above floor or 1" above toekick. 23-1/4" 

from floor to bottom of cutout is recommended 
for under countertop installation.

Warming drawers are approved for installation below only
certain specified cooktop models. See the label attached
to the top of the warming drawer for approved models. 
A solid barrier and air gap between cooktop and warming
drawer is required. See Note above. 

ZTD910

28-1/2"

ZKD910

25-1/2"