Monogram ZTD910SFSS Instrução De Instalação

ANTI-TIP PRECAUTIONS
An anti-tip brace must be installed to prevent 
the drawer from tipping forward when opened 
and loaded. Failure to do so could result in 
personal injury.

IMPORTANT: When installed below a single or double oven, check to be sure 
that any oven supports above the cutout do not obstruct the 23-1/2" required depth 
of the warming drawer cutout.

• A 2" min. clearance between oven and warming drawer

cutouts are required. Additional clearance may be
required if 2 x 4 blocks are used to support runners 
or solid floor of the oven above.

• The warmer drawer may be supported by either 

a solid bottom,  2 x 4  or 2 x 2 runners.

• The support must be level and rigidly mounted, 

flush with the bottom edge of the cutout. 
– There is no way to level the drawer once it 

has been installed. Be sure supports are level.

• The entire weight of the drawer is supported by 

the runners or solid floor and must be capable 
of supporting 150 lbs.

• Slide the left corner of the drawer into the opening.
• Push the power cord into the hole leading to the outlet

location. Thread the cord through as the drawer is being
pushed back into the opening. Check to be sure the
power cord does not get trapped under the drawer.
– If the outlet is installed inside the opening, plug the cord

into the outlet. In this location, the excess power cord
length should be coiled and taped to the right side 
of the unit.

• Push the drawer back until the front flange is flush 

to the cabinet front.

• Open the drawer fully.
• Drill pilot holes through the holes in the overlapping 

frame, one on each corner.

• Drive the wood screws provided into each corner.

Install 2x4 or 2x2

Anti-Tip Block

Against Rear

Cabinet Wall 9"

From Floor to

Bottom of Block

2x4 or 2x2

Runners or Solid

Bottom

9"

23-1/2"

22"

27"

2"x4" or 

Equivalent Runners

23-1/2"

2"x4" or 

Equivalent Runners

25"
30"