Monogram ZTD910SFSS Instrução De Instalação

2x2 or 2x4 Anti-Tip
Block Against Rear

Wall, 9" From Floor

to Bottom of Block

2x2 or 2x4 Anti-Tip
Block Against Rear

Wall, 9" From Floor

to Bottom of Block

1" Min. Above Toekick or Adjust
to Oven Installation Height

1" Min. Above Toekick

Allow 5/8"
Overlap on

All Sides

23-1/2" Min.

Inside

23-1/2" Min.

Inside

Oven

Cutout

Oven

Cutout

2" Min.

2" Min.

9"

9"

A

A

B

B

9-1/4"

9-1/4"

23-1/4"

23-1/4"

10-1/2"

10-1/2"

Allow 5/8"
Overlap on

All Sides

NOTE: Additional clearance between cutouts may 
be required. Check to be sure that oven supports 
above the Warming Drawer location does not obstruct 
the required interior 23-1/2" depth and 9-1/4" height.

NOTE: Additional clearance between cutouts may 
be required. Check to be sure that oven supports 
above the Warming Drawer location does not obstruct 
the required interior 23-1/2" depth and 9-1/4" height.

ZTD910

28-1/2"

30"

ZKD910

25-1/2"

26-3/4"

Warming drawers are approved for installation below only
certain specified wall oven models. See the label attached 
to the top of the warming drawer for approved models. 
• When installed, the front face of the drawer 

will be nearly flush with adjacent cabinetry doors.

• Drawer overlaps will conceal cut edges 

on all sides of the opening.

The rough opening for the drawer must be:

– Depth: 23-1/2" min. from inside back to front 

of cabinet frame.

– Width: 25-1/2" for 27" wide models, 

28-1/2" for 30" wide models.

– Height: 9-1/4".
–  Allow 2" min. between oven and drawer cutouts 

for clearance of overlaps.

NOTE: If you are installing in frameless cabinets, it may 
be necessary to install 1/2" wide cleats to accept drawer
mounting screws. See drawer for mounting screw locations.