Справочник Пользователя для Mitsubishi Electronics 60/60S
6. Data In/Out
6.7 Data Protection
I-266
6.7 Data Protection
6.7.1 Data Protection Key
Data protection keys can inhibit data from being set or erased. There are three types of data protection keys
as shown below (the key names depend on the machine makers. For the details, refer to the manuals
issued by individual machine makers).
as shown below (the key names depend on the machine makers. For the details, refer to the manuals
issued by individual machine makers).
1) KEY 1: Protection of all tool data and coordinate system values preset by origin setting
2) KEY 2: Protection of user parameters and common variables
3) KEY 3: Protection of work programs
The data protection keys protect data when they are turned off.
CRT data
setting screen
KEY1
Tool data
User parameters
Machining programs
Data protection key
Target data
KEY2
KEY3
1) Protection of tool data (KEY 1)
When KEY 1 is OFF, the operation items listed in Table 1 are inhibited.
Table 1 Data protection by KEY 1
No. Operation
Screen
1 Origin
setting
MONITOR/POSITION
2
Setting/erasing of tool nose wear compensation TOOL/COMP TOOL TIP OFFSET
3
Setting/erasing of tool length offset
TOOL/COMP TOOL DATA
4
Setting/erasing of nose-R compensation,
wear compensation and tool nose point
wear compensation and tool nose point
TOOL/COMP NOSE-R/P
5
Setting/erasing of tool life data
TOOL/COMP TOOL LIFE
6
Setting/erasing of workpiece coordinate offset
data
data
PARAM/WORK OFFSET
7
Tape input of tool offset data
IN/OUT INPUT
8
Tape output of tool offset data
IN/OUT OUTPUT
(Note) When key 1 is OFF, no data is input by pressing any key other than the MENU key on the
screens corresponding to numbers 2 to 6 in Table 1. Instead, it will display the message "DATA
PROTECT".
PROTECT".
You can't set the origin by pressing the
C.B
CAN
key on the POSITION/COORDINATE screen.
Only the message "DATA PROTECT" will be displayed.
Manual numeric command also cannot be carried out on the TOOL screen.
When an attempt is made to perform the operation of number 7 or and/or 8, you cannot input or
output data through the input key. Instead, the message "DATA PROTECT" will be displayed.