Справочник Пользователя для Mitsubishi Electronics 60/60S

Appendix 7. 

Operation Messages on Setting and Display Unit

 

 

 

IV-23 

 
 

If a setting operation error occurs on any setting and display unit screen, the error No. E

 and a message 

describing the details of the error will display in the line above the data setting area or the menu display 
area. 

∆: Message requiring resetting and restarting 
×: Message requiring restarting after canceling error conditions. 

(The bold characters are the messages displayed on the screen.) 

Error No. 

Error message 

Details 

∆  •  The setting data is incorrect. An alphabetic character was set 

when only number can be set‚ etc.  

•  Data was input without setting number (#). 

 (Word 

editing) 

•  Even though no retrieval data was set, menu key [ 

↓ ] or [ ↑ ] was 

pressed. 

•  Even though no data is stored in edit buffers, menu key 

“Replace” was pressed. 

•  One of the following characters was entered as the first character 

of the retrieval data and edit buffers: 0 to 9, “. ”, “ ” (space), “+”, 

“

−”, “=”, “*”, “[ ] ”, and “ " " ”. 

 

•  When the incremental detection system was used, the parameter 

(#0 absolute position setting) was set on the absolute position 
setting screen. 

 

•  The data input for the standard parameter setting or during 

execution of formatting is not “Y” or “N”. 

 

•  A value from 4 to 10 was specified for #1043 lang. 
•  Even though no language data exists, its output and comparison 

were attempted.  Check the numbers (0253 and 0254) of the 
language data to be output. 

 

•  When the machine manufacturer macro program memory area is 

the SRAM area, the setup parameter #1060 SETUP was set to 
“20”. 

•  When the machine manufacturer macro program memory area is 

the SRAM area, writing of the machine manufacturer macro 
program was attempted on PROGRAM COPY screen. 

∆  •  The setting data exceeded the setting range. 

 

 

 

•  The compensation data specification exceeded the range when 

inputting the tool offset data on tape‚ so that block could not be 
input. Press the INPUT key again while the input screen is 
displayed‚ and the input will continue from the next block. 

 

 

 

•  When workpiece coordinate offsets are measured, the 

calculation results given by pressing the CALC key are 
exceeding the specified range.  Correctly specify the tool length 
or the wear data of cutting edges used for the calculation. 

 

 

 

•  #1003 iunit was set to D when the least increment command 

0.01µm option was not available. 

 

 

 

•  When there was no option, 2 or more was specified for #1043 

lang.  Otherwise, an option was added and 23 or more was 
specified for #1043 lang.