Справочник Пользователя для Mitsubishi Electronics 60/60S

Appendix 7. 

Operation Messages on Setting and Display Unit

 

 

 

IV-24 

 

Error No. 

Error message 

Details 

∆  •  The corresponding setting No. (#) was not found. This error 

occurs if a setting No. not found on the screen was set and input‚ 
or if a variable No. not found in the specifications was set and 
input for the common variables. 

•  When the tool length was measured manually, a nonexisting tool 

wear compensation number was specified and the sensor was 
turned ON.  Specify the R register of the offset number correctly.

×  •  The input/output unit power is not ON.  

•  The cable is disconnected. 
•  Setting of the transfer speed (baud rate) does not agree. 

×  •  The PLC timer cannot be set from the screen when the program 

is valid. (When machine parameter bit selection #6449 bit 1 is set 
to 1.) 

•  The PLC counter cannot be set from the screen when the 

program is valid. (When machine parameter bit selection #6449 
bit 0 is set to 1.) 

 

•  The tool registration data setting is prohibited. (When special 

relay E71 is valid by the PLC.) 

•  Setting from the tool life management screen is prohibited. 

 

•  Absolute position setting screen’s #1 “ORIGIN” and #2 “ZERO” 

cannot be set when #0 “INIT SET” is invalid. 

 

•  The total of axes set in #1001 SYS_ON‚ #1002 axisno is illegal. 

Set so that the total No. of axes is within the specifications range 
for the target model. 

•  #1037 cmdtyp is not within the setting range. 

 

•  The INPUT key was pressed to perform search for the program 

that is in background edit status on the word edit screen. 

•  The menu keys (Replace and Insert) on the word edit screen 

were manipulated when a running program is displayed (PDISP 
signal: ON). 

•  An attempt was made to set MDI data in an MDI setting lock state 

(the MDI setting lock parameter is specified with 0 and a non-MDI 
mode is valid). 

 

•  Language data in display selection status was entered.  Change 

the display selection status once before entering the data.  
(#1043 lang) 

 

•  When the manual value command protection (#1228 aux12/bit7) 

function is valid, the first monitor screen was manipulated by 
manual command operation (M, S, and T keys).