Справочник Пользователя для Mitsubishi Electronics 60/60S

Appendix 7. 

Operation Messages on Setting and Display Unit

 

 

 

IV-25 

 

Error No. 

Error message 

Details 

×  •  The menu key for a function not in the specifications was 

pressed.  

•  A parameter not in the specifications was set. 
•  A language that was not added as an option was selected.  

(#1043 lang) 

•  Set up parameter #1049 mmac_R was set to “1” when the 

machine manufacturer macro option was not valid. 

•  Set up parameter #1060 SETUP was set to “20” when the 

machine manufacturer macro option was not valid. 

•  Writing of the machine manufacturer macro program with the 

PROGRAM COPY screen was attempted when the machine 
manufacturer macro option was not valid. 

∆  •  The input/output operations were forcibly stopped by reset‚ etc. 

(including EMG). 

×  •  The input/output parameter setting or input/output unit side 

setting was incorrect. 

×  •  The input/output unit parameter “#9116 TIME-OUT SET” setting 

was too short. 

•  There is no EOB code in the machining program.  

×  •  The program cannot be written because the memory capacity is 

exceeded. 

•  This error occurs when the MDI data setting on the MDI screen 

exceeds 500 characters‚ or when saving MDl‚ editing or making a 
program on the edit screen‚ input on the data input/output screen‚ 
program copy‚ etc. 

∆  •  When registering a machining program in the memory‚ a program 

with the same No. as the designated program No. was found in 
the memory. Refer to the program file to find a program No. not 
being used‚ and reset the program No. 

•  A program with the same No. as the machining program to be 

copied from the memory was found in the IC card. 

•  This error occurs during MDI registration in the MDI screen or 

during creation of a program in the edit screen. 

×  •  When registering a machining program in the memory‚ the No. of 

programs determined in the specifications is exceeded‚ 
preventing registration. 
This error occurs during MDI registration in the MDI screen‚ 
creation of a program in the edit screen‚ data input in the data 
input/output screen‚ and program copy. 

∆  •  The block with the designated sequence No. or block No. does 

not exist in the designated program. 

∆  •  The designated program is not found in the memory.  

•  The corresponding program No. was not found with search of 

tape memory during graphic check.