Справочник Пользователя для Mitsubishi Electronics 60/60S

2.  Monitor 

2.5  Resuming the Program 

 

 

 

I-57 

1)  Restart type 3 is valid only with the lathe system. 

2)  When using the 2-part system, the system name of the currently selected system is displayed as 

$1 (system 1) and $2 (system 2). This is not displayed when using a 1-part system. (Only L 
system) 

3)  When using the 2-part system, the methods for searching for the program and block to be 

restarted can be switched with the parameters. 

0, 2, 4, 6 

- 

The machining program block registered in the memory common for 
systems is searched. 

1, 3, 5, 7 

OFF 

The machining program block registered in the memory for the selected 
system is searched. 

 

ON 

The machining program block registered in the memory for the selected 
system is searched. 
If the subprogram for the selected system is empty, the corresponding 
block is searched from the program with the same number saved in the 
$1 memory. (Only type B)