Справочник Пользователя для 3com SuperStack II

Connect a PC running a terminal emulation program, a terminal, or a 
modem to the console port on the SuperStack II bridge/router to 
configure the bridge/router software and review startup and system 
operation messages.

To connect a PC, terminal, or modem to the bridge/router, follow 
these steps:

1 Obtain a cable to connect the device to the console port on the 

bridge/router. See “Console Connector and Cables” on page 163 for 
cable pinouts.

The console port is a 9-pin male connector. 

For the PC, use a 9-pin female to 9-pin female null modem-type cable.

For the terminal, use a 9-pin female to 25-pin null modem-type cable.

For the modem, use a 9-pin female to 25-pin male straight-through-type 
cable.

2 Connect one end of the cable to the console port on the SuperStack II 

system and the other end to the serial port on the back of your device.

3 Verify that configurable parameters of your device match the 

configuration settings of the console port specified in Table 8.

4 Turn on the device.

If your SuperStack II system is not connected to an RPS, turn off the 
power by pressing the off (0) side of the power switch on the back panel. 
If your system is connected to an RPS, turn off the power by unplugging 
the RPS cable from the system and then pressing the off (0) side of the 
power switch.

Table 8   Console Port Configuration Settings

Baud rate

9600

Databits

8

Parity

None

Stop bits

1

DTR

Ignored

Duplex

Full

Echo

Off

Flow control

X-on/X-off