Справочник Пользователя для Mitsubishi Electronics E60
6.
AXIS SPECIFICATIONS PARAMETERS
6.3
Absolute Position Parameters
II - 92
6.3 Absolute Position Parameters
(SETUP PARAM 2. 5/8)
#
Items
Details
Setting range (unit)
2049
(PR)
type Absolute
position
detection
method
detection
method
Specify the absolute position zero point alignment
method.
method.
0: Not absolute position detection
1: Stopper method (push with mechanical stopper)
2: Origin point alignment method (align with
1: Stopper method (push with mechanical stopper)
2: Origin point alignment method (align with
marked point)
3: Dog-type (align with dog and proximity switch)
4: Reference point alignment method II (align to
4: Reference point alignment method II (align to
alignment mark)
(Type that does not return grid after reference
alignment)
alignment)
9: Simple absolute position
(Not absolute position detection‚ but the position
when the power is turned off is registered.)
when the power is turned off is registered.)
Automatic initial setting is valid only when the stopper
method is selected.
method is selected.
0 to 9
2050 absdir
Base point
of Z
direction
of Z
direction
Set the direction of the absolute position reference point
(grid point immediately before) seen from the machine
reference point for when using reference point
alignment.
(grid point immediately before) seen from the machine
reference point for when using reference point
alignment.
0: Positive direction
1: Negative
1: Negative
direction
2051 check
Check
Set the tolerable range for the movement amount
(deviation amount) when the power is turned OFF.
(deviation amount) when the power is turned OFF.
0: Not checked
1 to 99999.999mm: If the difference of the position
1 to 99999.999mm: If the difference of the position
when the power is turned OFF
and turned ON again is larger
than this value‚ an alarm will
be output.
and turned ON again is larger
than this value‚ an alarm will
be output.
0 to 99999.999 (mm)
2052 absg28
Not used.
2053 absm02
Not used.
2054 clpush
Current limit
(%)
(%)
Set up the current limit value for the initial setting when
detecting an absolute position with a dog-less system.
The setup value is the ratio of the current limit value to
the rated value.
detecting an absolute position with a dog-less system.
The setup value is the ratio of the current limit value to
the rated value.
0 to 100 (%)
2055 pushf
Push speed Set the feedrate for the automatic initial setting during
stopper method.
1 to 999 (mm/min)
2056 aproch
Approach
Set the approach distance for the automatic initial
setting in the push method.
Approach distance:
setting in the push method.
Approach distance:
After using stopper once‚ the
tool returns this distance‚ and
then use stopper again.
When set to 0‚ the reference
point coordinates set in #2037
G53ofs will be used as the
approach start position.
tool returns this distance‚ and
then use stopper again.
When set to 0‚ the reference
point coordinates set in #2037
G53ofs will be used as the
approach start position.
0 to 999.999 (mm)