Справочник Пользователя для Mitsubishi Electronics E60

II - 93 

 

# 

Items 

Details 

Setting range (unit) 

2057 nrefp 

Near zero 
point + 

Set the width where the near-reference-point signal is 
output. (Positive direction width)  
When set to 0‚ the width is equivalent to the grid width 
setting. 
Note:   When #1240 set12 (bit2) is ON, a magnification 

(C: 10-fold) corresponding to the input setting 
unit (#1003 iunit) will be applied on the setting 
value.  

0 to 32.767 (mm) 

2058 nrefn 

Near zero 

point 

− 

Set the width where the near-reference-point signal is 
output. (Negative direction width) 
When set to 0‚ the width is equivalent to the grid width 
setting. 
Note:   When #1240 set12 (bit2) is ON, a magnification 

(C: 10-fold) corresponding to the input setting 
unit (#1003 iunit) will be applied on the setting 
value.  

0 to 32.767 (mm) 

2059 zerbas  Select zero 

point 
parameter 
and reference 
point 

Specify the position to be the zero point coordinate 
during absolute position initial setting.  

0:  Position that was stopped during stopper 

method 

 

Specify the coordinates of the alignment mark 
position when using the reference point 
method. 

1:  Grid point just before stopper  
 

Specify the coordinates of the grid point just 
before the alignment mark. 

0/1