Инструкции По Установке для 3com S7906E

 

1-16 

Configure the maximum 
number of load balanced routes 

balance number 

Required 

By default, no load balancing is 
enabled. 

 

In a large-scale IPv6 BGP network, configuration and maintenance become no convenient due to too 

many peers. In this case, configuring peer groups makes management easier and improves route 

distribution efficiency. Peer group includes iBGP peer group, where peers belong to the same AS, and 

eBGP peer group, where peers belong to different ASs. If peers in an eBGP group belong to the same 

external AS, the eBGP peer group is a pure eBGP peer group, and if not, a mixed eBGP peer group.  

In a peer group, all members enjoy a common policy. Using the community attribute can make a set of 

IPv6 BGP routers in multiple ASs enjoy the same policy, because sending of community between IPv6 

BGP peers is not limited by AS.  

To guarantee connectivity between iBGP peers, you need to make them fully meshed, but it becomes 

unpractical when there are too many iBGP peers. Using route reflectors or confederation can solve it. In 

a large-scale AS, both of them can be used. 

Confederation configuration of IPv6 BGP is identical to that of BGP4, so it is not mentioned here. The 

following describes: 

z 

Configuring IPv6 BGP peer groups 

z 

Configuring IPv6 BGP community 

z 

Configuring IPv6 BGP route reflectors 

Before configuring IPv6 BGP peer groups, you need to: 

z 

Make peer nodes accessible to each other at the network layer 

z 

Enable BGP and configure a router ID. 

Follow these steps to configure an iBGP group: 

Enter system view 

— 

Enter BGP view 

bgp as-number 

— 

Enter IPv6 address family view 

ipv6-family 

— 

Create an iBGP peer group 

group ipv6-group-name 
[ internal ] 

Required 

Add a peer into the group 

peer ipv6-address group 
ipv6-group-name [ as-number 
as-number ] 

Required 

Not added by default