Руководство Пользователя для Spectra Logic nastape 100
Chapter 4. Using the Serial Port Interface
33
Ethernet Configuration
The NAStape is shipped with DHCP enabled and a preset hostname based on the serial
number of the board. The Ethernet port is assigned a default hostname of
SL-0000<serial number>-0, where <serial number> is the serial number of the NAStape,
located on the rear panel of the NAStape. This hostname may be changed using the
Ethernet Configuration Menu.
number of the board. The Ethernet port is assigned a default hostname of
SL-0000<serial number>-0, where <serial number> is the serial number of the NAStape,
located on the rear panel of the NAStape. This hostname may be changed using the
Ethernet Configuration Menu.
Before attaching the NAStape to your network, these values should be set as
appropriate for your site.
appropriate for your site.
1.
To launch the Ethernet Configuration Menu, select
3
from the TAOS
Configuration Menu.
The Ethernet Configuration Menu appears (Figure 4-4).
2.
To configure the Ethernet port, use the following options:
[1] DHCP:
Select to enable DHCP. When DHCP is enabled, the hostname is used as
part of the system identification. If DHCP is disabled, you must provide a static
IP address.
IP address.
Note:
If DHCP is used, the IP address should never expire. The DHCP
servers should be configured to supply an IP address that will
never change.
servers should be configured to supply an IP address that will
never change.
Figure 4-4 The Ethernet Configuration Menu.