Release Note для Spectra Logic spectra t120

Chapter 8 – QIP Replacement

127

After you replace an LCM and the library restarts, restore the partition definitions and 
library configuration settings using one of the following methods.

ƒ If SpectraGuard Support directs you to do so, remove the card from the LCM you 

replaced and install it in the new LCM compact flash slot as described in the Spectra 
T120 Assisted Self Maintenance Guide.

ƒ Use an auto-save configuration file you previously saved to a USB storage device to 

restore the library configuration and MLM database (see Restoring the Library From 
an Auto-Save Configuration File on page 77).

ƒ If you do not have an auto-save configuration file available, refer to the Spectra 

T120 User Guide for information about using the advanced utilities to restore a 
previously saved library configuration file. See Restoring the MLM Database on 
page 81 for information about restoring the MLM database using a previously saved 
backup. If necessary, update the configuration to the most current settings after the 
restore is complete.

ƒ If you do not have any backups of the library configuration, re-enter all of the 

configuration settings using the information you recorded in Before You Begin on 
page 126). Refer to Chapter 6 – Loading Media and More Configuration on page 46 
for detailed instructions.

ƒ Refer to Chapter 12 – Configuring and Using Encryption on page 95 for 

information about reimporting encryption keys.

The pins on QIPs are packaged with a protective covering. Remove the covering so the 
pins are exposed before installing the QIP. 

Caution

Do not install the compact flash card from the LCM you 
replaced unless directed to do so by SpectraGuard Support. 
Installing a corrupted compact flash card can cause the new 
LCM to fail.