Release Note для Spectra Logic spectra t120
BlueScale10.4-20080908F
129
BlueScale10.4-20080908F
Enhancements
BlueScale10.4 adds the following new features:
Hardware Health Monitoring (see BlueScale Hardware Health Monitoring on
Auto Configuration Save (see Auto-Save Library Configuration and MLM
The library now tracks and reports the total number of moves by category.
This release provides improved library operation and improved compatibility with
This release provides improved library operation and improved compatibility with
LTO-4 tape drives.
ScanDisk automatically scans the compact flash when the library starts up.
Caution
Starting with the BlueScale10.4.0 firmware, IBM LTO-4 tape
drives must be using firmware version 8940 or later.
drives must be using firmware version 8940 or later.
Important
If you plan to upgrade the Fibre Channel tape drives in your
library from LTO-3 to LTO-4, read Reconfiguring Your SAN or
HBA WWNN or WWPN Settings on page 20 for important
information. Changes to the way a library generates the World
Wide Node Name (WWNN) and World Wide Port Names
(WWPN) for LTO-4 Fibre Channel drives will affect your SAN
or HBA configurations.
library from LTO-3 to LTO-4, read Reconfiguring Your SAN or
HBA WWNN or WWPN Settings on page 20 for important
information. Changes to the way a library generates the World
Wide Node Name (WWNN) and World Wide Port Names
(WWPN) for LTO-4 Fibre Channel drives will affect your SAN
or HBA configurations.
Important
The IBM LTO-4 Fibre Channel drives currently shipping with
the library are equipped two Fibre Channel ports. Read Using
Dual-Port Fibre Channel LTO-4 Tape Drives on page 22 for
important information. To enable and use the dual ports:
the library are equipped two Fibre Channel ports. Read Using
Dual-Port Fibre Channel LTO-4 Tape Drives on page 22 for
important information. To enable and use the dual ports:
Your library must be using BlueScale10.4.0 or later
firmware.
The LTO-4 Fibre Channel drives must be using firmware
If an LTO-4 Fibre Channel drive is connected to a SAN using
zoning or to an HBA using persistent binding, you may also
need to update your SAN or HBA configuration to include
the WWPN for Port B, as described in Step 4 on page 21.
need to update your SAN or HBA configuration to include
the WWPN for Port B, as described in Step 4 on page 21.