Справочник Пользователя для Savi Technology Inc 600SP-V1
0RXQWLQJWKH6LJQSRVWV
(FKR3RLQW6LJQSRVW,QVWDOODWLRQ*XLGH
&DEOLQJWKH0RGHO636LJQSRVW
The connectors and LED shown in Table 2-4 are available on a Model
SP-600-101 Signpost.
SP-600-101 Signpost.
»
To cable a Model SP-600-101 Signpost
1. Cable the Model SP-600-101 the same as the Model SP-600-201.
For cabling, the Model SP-600-101 is identical to the cabling
for the Model SP-600-201 except that the Model SP-600-101
has an internal antenna.
for the Model SP-600-201 except that the Model SP-600-101
has an internal antenna.
2. Continue with configuration using the Signpost configuration
software.
7DEOH
0RGHO636LJQSRVW&RQQHFWRUVDQG/('V
Connectors
and LEDs
and LEDs
Description
Power
The input power is connected here.
RS-232
Used to connect to a computer for setup and diagnostics by installers
and technicians.
and technicians.
Sync In
Used to synchronize 2 to 4 Model SP-600-101 Signposts to cover an
area larger than is possible with a single Signpost. This connector can
also accept DC volts from another Signpost to avoid running separate
power lines when two or more Signposts are synchronized
area larger than is possible with a single Signpost. This connector can
also accept DC volts from another Signpost to avoid running separate
power lines when two or more Signposts are synchronized
Sync Out
Used to synchronize 2 to 4 Model SP-600-101 Signposts to cover an
area larger than is possible with a single Signpost. This connector can
also output DC volts to another Signpost to avoid running separate
power lines when two or more Signposts are synchronized
area larger than is possible with a single Signpost. This connector can
also output DC volts to another Signpost to avoid running separate
power lines when two or more Signposts are synchronized
Sensor 1
A closure on these two pins will trigger a predefined Signpost action.
Sensor 2
A closure on these two pins will trigger a predefined Signpost action.
Status
This LED indicates when power is applied and the Signpost mode of
operation:
operation:
On ½ second, off ½ second indicates normal operation
On 1 second, off 1 second indicates the Signpost is off but powered
On continuously indicates the Signpost is transmitting a CW signal