Справочник Пользователя для Packard Bell REFDOCS02420200

 

9

3.  Remove the screw on the side of the hard disk drive bracket holding it to the drive 

bracket above (see Fig 6 in section Removing the Drive Bracket). 

4.  Slide the hard disk drive bracket backwards out of the chassis. 

 

 

 

5.  Remove the screws that hold the hard disk drive in the bracket and slide it out. 

 
 

To remove add-in cards, first remove the rear bezel (see section Removing the Rear Bezel) 
and remove the left side cover (see section Removing the Left Side Cover); then follow the 
steps below: 
 

1.  Disconnect all cables from the add-in card to be removed. 
2.  Press the two metal clips until the retention bracket unlocks and remove the 

bracket. 

 

 

 

3.  Carefully take out the card from the slot. 

 
 

To remove the front USB port, first remove the rear bezel (see section Removing the Rear 
Bezel) and remove the left side cover (see section Removing the Left Side Cover), remove 
the front bezel (see section Removing the Front Bezel); then follow the steps below: 
 

1.  Disconnect the USB port cable on the motherboard and/or on the USB port itself. 
2.  Remove the screws holding the USB port to the chassis.