Справочник Пользователя для Samsung iDCS 100

NOTE: If the Hot Keypad feature has been turned off, you must first lift the
handset or press the SPK or the MONITOR key if you are using a 7B phone
before dialing.

Press the NEW button to disconnect your existing call, wait for dial tone and
then make a new call on the same line.

NOTE: If this button does not appear on your keyset, the FLASH key may
be programmed to recall dial tone. 

While on an outside call, press the FLASH key to send a flash to the tele-
phone company. This is required for some custom calling features or CEN-
TREX use.

NOTE: Flash is not available on an ISDN circuit.

If you receive a busy signal when you are selecting an outside line, this
means that the line or group of lines is busy.

•

Press the CBK key, if programmed, or dial 44. You will hear confirmation
tone.

•

When the line becomes free, the system will call you back.

•

Lift the handset or press the ANS/RLS key to answer, wait for dial tone
and dial the telephone number or speed dial number again.

NOTES:
1.

A callback will be canceled if not answered within 30 seconds. If you
have set a callback, your CBK key will light.

2.

If the Hot Keypad feature has been turned off, you must first lift the hand-
set or press the SPK or  MONITOR key if you are using a 7B phone
before dialing.

A callback will be canceled if not answered within 30 seconds. If you have
set a  callback, your CBK key will light.

Your phone may have a maximum of five callbacks to lines and/or stations
set at a time. To cancel a callback:

•

Press the CBK key, if programmed, or dial 44. You will hear confirmation
tone.

11

10

•

Lift the handset and press an idle outside line button, line group button
or dial a line access code to receive dial tone—OR—to use the speak-
erphone, press an idle outside line button, line group button or dial a line
access code to receive dial tone through the speaker—OR—press SPK
or the MONITOR key if you are using a 7B phone, receive intercom dial
tone and dial a line access code.

•

Dial the telephone number.

•

Finish the call by replacing the handset or pressing the ANS/RLS key.

NOTE: You will receive No More Calls tone when you attempt to make a call
and there is no key available for that line.

•

If Least Cost Routing is enabled on your phone system, this button may
be labeled LCR or accessed by dialing an access code (usually 9).

•

If your system is programmed to require an authorization code before
making a call, dial 4 plus a valid code before selecting a C.O. line.

•

If your system is programmed to require an account code before mak-
ing a call, press the ACCT button or dial 47 plus a valid code, press the
ACCT button again and then select a C.O. line.

For more information on authorization and account codes, see your system
administrator.

NOTE: If the Hot Keypad feature has been turned off, you must first lift the
handset or press the SPK or the MONITOR key if you are using a 7B phone
before dialing.

•

Lift the handset and you are automatically connected to the ringing call. 

—OR—press the

ANS/RLS key to automatically answer on the speakerphone.

NOTE: If a call is flashing at your keyset but not ringing, you must press the
flashing button to answer.

Outside lines may be programmed to ring a general alerting device. To
answer calls ringing this device, dial 67 or press the UA key. This device can
operate in any one of the six different ring plans.