Roland VS-1824 用户手册
117
Chapter 8 EZ Routing
Chapter 8
10. Select mixer channels to be output to the AUX bus.
The AUX bus is useful for creating a separate headphone
mix for the performer you are recording, or for sending
mix for the performer you are recording, or for sending
tracks to an external effects processor. Use [
],
[
], [
], and [
] to move the cursor and the
TIME/VALUE dial to adjust each of the values.
fig.02-28
11. Press [F2 (STEP
→
)]. You can return to the previous
screen by pressing [F1 (STEP
←
)].
12. Select the Master Section settings. Use [
], [
],
[
], and [
] to move the cursor and the TIME/
VALUE dial to adjust each of the values.
fig.02-29
13. Press [F4 (Exec)]. “EZ ROUTING Step Edit is finished!!”
appears in the display.
fig.02-24a
WARNING:
EZ Routing settings will override any existing
mixer settings you have already made.
14. You can save your setup as an EZ Routing template, or
Exit [F6 (EXIT)] to leave this display without saving. To
save the setup, press [F3 (SAVE)]. The Routing Save
screen appears in the display. Save the setup using the
procedure described in “Saving an EZ Routing
Template,” p. 123.
save the setup, press [F3 (SAVE)]. The Routing Save
screen appears in the display. Save the setup using the
procedure described in “Saving an EZ Routing
Template,” p. 123.
Setting Up for Bouncing Using
Step Editing
Step Editing
Select this when bouncing audio recordings from a group of
tracks onto another track or tracks. To cancel the settings
procedure, press [F6 (EXIT)].
tracks onto another track or tracks. To cancel the settings
procedure, press [F6 (EXIT)].
1. Press [EZ ROUTING].
The EZ Routing icon appears in the display.
2. Press [F5 (Exec)]. If “Exec” does not appear in the display
above [F5], press [PAGE] until you see “Exec,” and then
press [F5 (Exec)].
press [F5 (Exec)].
3. Press [F3 (Bounc)].
fig.02-18
4. Specify the source tracks for the bounce and the
destination track(s). First press the Track SELECT for the
source track, then press the Track STATUS button for the
destination track. Using this method, you can assign a
single source track to two different destination tracks for
source track, then press the Track STATUS button for the
destination track. Using this method, you can assign a
single source track to two different destination tracks for
recording. Use [
] and [
] to move the cursor and
the TIME/VALUE dial to select the V-Track for both the
source tracks as well as for the track you want to record
on.
source tracks as well as for the track you want to record
on.
* You can only assign the bounce to one track-linked destination.
* You cannot assign a stereo-linked track to tracks that are not
linked. For example, it is not possible to assign source Tracks
9/10 to record on Tracks 3 and 4 unless you first turn Channel
Link to “On” for Track 3.
9/10 to record on Tracks 3 and 4 unless you first turn Channel
Link to “On” for Track 3.
fig.02-31
AUX Switch
AUX Send Switch
AUX Send Pan/
Balance
Balance
Cursor
Input Channel
Track Channel
Monitor Select
Equalizer Mode
Direct Out
Effect Insert
Playback track assigned to be recorded on a track
Playback Track
Recording Track
V-Track