Sanyo PLC-WXU700A 用户手册

When the projection lamp of the projector reaches its end 

of life, the Lamp replacement icon appears on the screen 

and LAMP REPLACE indicator lights yellow. Replace the 

lamp with a new one promptly. The timing when the LAMP 

REPLACE indicator should light is depending on the lamp 

mode.

For continued safety, replace with a lamp of the 

same type. Do not drop a lamp or touch a glass 

bulb! The glass can shatter and may cause injury.

Allow a projector to cool for at least 45 minutes 

before you open the Lamp Cover. The inside of 

the projector can become very hot.

Lamp replacement icon

Replacement lamp can be ordered through your dealer.  When ordering a projection lamp, give the following 

information to the dealer.

 

●

  

 

●

 

 

Follow these steps to replace the lamp.

Turn off the projector and unplug the AC power cord. 

Let the projector cool for at least 45 minutes.

Loosen the two (2) screws that secure the lamp. Lift 

the lamp out of the projector by using the handle.

Replace the lamp with a new one and secure the two 

(2) screws. Make sure that the lamp is set properly. 

Close the lamp cover and secure the screw.

Remove the screw and open the lamp cover.

Connect the AC power cord to the projector and turn 

on the projector.

See “Resetting the Lamp Counter” on the next page.

Handle

Screw

Lamp Cover

Press here and pull upward.

Screw

Lamp

Screw

WARNING: 

TURN OFF THE UV LAMP BEFORE 

OPENING THE LAMP COVER



  The Lamp replacement icon will not appear when the Display function

  is set to 

Off (p.49), during "Freeze" (p.28), or "No show" (p.29).