Sanyo PLC-WXU700A 用户手册

This projector uses a high-pressure lamp which must be handled carefully and properly.  

Improper handling may result in accidents, injury, or create a fire hazard.

●

 Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee 

of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time 

than other similar lamps.

●

 If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights 

up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.  

    (Follow carefully the instructions in the Lamp Replacement section of this manual.) Continuous use of 

the lamp with the LAMP REPLACE indicator lighted may increase the risk of lamp explosion.  

●

 A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its 

lifetime  draws  to  an  end.  Risk  of  explosion  may  differ  according  to  the  environment  or  conditions  in 

which the projector and lamp are being used.

If  a  lamp  explodes,  disconnect  the  projector’s AC  plug  from  the AC  outlet  immediately.  Contact  an 

authorized  service  station  for  a  checkup  of  the  unit  and  replacement  of  the  lamp. Additionally,  check 

carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out 

from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one 

should  check  the  inside  of  the  projector  except  those  who  are  authorized  trained  technicians  and  who 

are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those 

who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken 

glass.  

Be sure to reset the Lamp counter after the lamp is replaced. When the Lamp counter is reset, the LAMP 

REPLACE indicator stops lighting and the Lamp replacement icon disappears.



    Do  not  reset  the  Lamp  counter  without  implementing 

lamp  replacement.  Be  sure  to  reset  the  Lamp  counter 

only after replacing the lamp.

Lamp counter Reset? 

appears.

Select 

yes, then another 

confirmation box appears.
Select 

yes again to reset 

the Filter counter.

Press the MENU button to display the On-Screen 

Menu. Use the Point 

▲▼

 buttons to select 

Setting and 

then press the Point 

► or the SELECT 

 button.

Use the Point 

▲▼

 buttons to select 

Lamp counter 

and then press the SELECT button. Use the Point 

▲▼

 

buttons to select 

Lamp counter reset and then press 

SELECT button. 

Lamp counter Reset? appears. 

Select 

yes to continue.

Another confirmation dialog box appears, select 

yes to 

reset the Filter counter.