Roland v-synth xt 业主指南

 

Enhancer, Phaser, Chorus or Flanger, and Tremolo or Auto-pan are 
connected in series. This effect is used for electric piano.

 

fig.MFX-36

 

A ring modulator, 3-band equalizer, pitch shifter, phaser, and delay 
are connected in series.

Ring Modulator is an effect which applies ring modulation using an 
internal oscillator to the input signal, producing bell-like sounds.

 

fig.MFX-37

 

Enhan Sw

OFF, ON

Turns the enhancer effect on/
off.

Enhan Sens

0–127

Sensitivity of the enhancer

Enhan Frequen-
cy

0–127

Sets the lower limit of the fre-
quencies to which the enhance-
ment effect is added.

Enhan Mix Lev-
el

0–127

Level of the overtones generated 
by the enhancer

Enhan Level

0–127

Volume of the enhancer sound

Phaser Manual

0–127

Specifies the center frequency at 
which the sound is modulated.

Phaser Rate

0.05–10.0 Hz, 
note

Specifies the frequency of mod-
ulation.

Phaser Depth

0–127

Specifies the depth of modula-
tion.

Phaser Reso-
nance

0–127

Specifies the amount of feed-
back for the phaser.
Higher settings will give the 
sound a stronger character.

Phaser Mix Lev-
el

0–127

Specifies the volume of the 
phase-shifted sound, relative to 
the direct sound.

Mod Mode 
(Chorus / 
Flanger)

CHORUS, 
FLANGER

Selects whether to use chorus or 
flanger.

Mod Rate

0.05–10.0 Hz, 
note

Adjusts the speed of modulation 
for the chorus or flanger.

Mod Depth

0–127

Adjusts the depth of modulation 
for the chorus or flanger.

Mod Phase

0–180 deg

Sets how the chorus or flanger 
sound is spread.

Mod Pre Delay

0–50.0 ms

Adjusts the delay time from the 
direct sound until the chorus or 
flanger sound is heard.

Mod Feedback

-98– +98%

Adjusts the proportion of the ef-
fect sound that is fed back into 
the effect. Negative (-) settings 
will invert the phase.

Mod XoverLPF

500–15000 Hz, 
THRU

Adjusts the cutoff frequency of 
the low pass filter. (THRU: no 
filter is used)

Mod XoverHPF THRU, 50–800 

Hz

Adjusts the cutoff frequency of 
the high pass filter. (THRU: no 
filter is used)

L

R

Phaser

Enhancer

Chorus/
Flanger

Tremolo/

Auto Pan

 

Mod Level

0–127

Volume of the chorus or flanger 
sound.

Trem/Pan Sw

OFF, ON

Turns the tremolo/auto pan ef-
fect on/off.

Trem Mode

TREMOLO, 
AUTO PAN

Selects whether to use tremolo 
or auto pan.

Trem Wave-
form

TRI, SAWUP, 
SAWDN, SQR, 
SIN

Selects the type of modulation.
TRI: Triangle wave
SAWUP/SAWDN: Sawtooth 
Wave
SQR: Square wave
SIN: Sine wave

Trem Rate

0.05–10.0 Hz, 
note

Frequency of modulation

Trem Depth

0–127

Depth of modulation

 

Ring Freq

0–127

Frequency at which modulation 
will be applied

Ring Balance #1 DRY100:0WET–

DRY0:100WET

Volume balance between the di-
rect sound (DRY) and the ring 
modulated sound (WET)

EQ Low Freq

50–4000 Hz

Frequency of the low range

EQ Low Gain

-15– +15 dB

Gain of the low range

EQ Mid Freq

50–20000 Hz

Frequency of the middle range

EQ Mid Q

0.5, 0.7, 1.0, 2.0, 
4.0, 8.0

Gain of the middle range
Set a higher value for Q to nar-
row the range to be affected.

EQ Mid Gain

-15– +15 dB

Gain of the middle range

EQ Hi Freq

2000–20000 Hz

Frequency of the high range

EQ Hi Gain

-15– +15 dB

Gain of the high range

SAWUP

SAWDN

L

R

3-Band

EQ

Ring

Modulator

Pitch

Shifter

Phaser

Delay

V-SYNTH_XT_e2 183 ページ ２００５年３月２３日　水曜日　午後４時３９分