LXE hx3 参考指南
36
Data Entry
HX3 Reference Guide
E-EQ-HX3RG-C
2D Imager
Figure 1-28 Imager Bracketed Crosshair Target on 2D Barcode
To scan with the Imager Ring Scanner, point the scan aperture towards a 2D barcode and press the
Scan button. You will see a bracketed crosshair strike the barcode. Align the brackets so that the
center of the barcode is covered by the crosshair.
Scan button. You will see a bracketed crosshair strike the barcode. Align the brackets so that the
center of the barcode is covered by the crosshair.
Move the ring scanner towards or away from the barcode until a response is emitted by the HX3
(1 beep, 2 beeps, a WAV file, etc) or the bracketed crosshair times out and disappears.
(1 beep, 2 beeps, a WAV file, etc) or the bracketed crosshair times out and disappears.
The Imager LED may illuminate when the Scan button is pressed. There are three options that can
be set by the System Administrator using the Scanner control panel applet: Internal illumination,
External illumination, or Both. If external illumination or both is chosen, there are three white
LEDs located above the imager aperture that will illuminate for the duration of the scan then turn
off.
be set by the System Administrator using the Scanner control panel applet: Internal illumination,
External illumination, or Both. If external illumination or both is chosen, there are three white
LEDs located above the imager aperture that will illuminate for the duration of the scan then turn
off.
See the previous section titled Tethered Ring Scanner / Imager figure titled Ring Scanner/Imager
Apertures.
Apertures.
Scan Status LED
Figure 1-29 Scan Status LED
The Scan Status LED (oval shaped LED on the top of the ring scanner) turns red when the laser
beam is on. Following a barcode scan and read the Scan Status LED turns green for two seconds
and the HX3 may beep, indicating a successful scan. If the scan was unsuccessful, the Scan Status
LED turns off and a different beep sequence may be heard.
beam is on. Following a barcode scan and read the Scan Status LED turns green for two seconds
and the HX3 may beep, indicating a successful scan. If the scan was unsuccessful, the Scan Status
LED turns off and a different beep sequence may be heard.
The ring scanner engine and Scan Status LED automatically turn off after a successful or
unsuccessful read. The ring scanner is ready to scan again after the Scan button is released, or
after the Scan Status LED turns off following a successful scan.
unsuccessful read. The ring scanner is ready to scan again after the Scan button is released, or
after the Scan Status LED turns off following a successful scan.
Voice Data
Data is entered into the HX3 by speaking into the headset’s microphone (or the internal
microphone located to the left of the LXE logo) when prompted.
microphone located to the left of the LXE logo) when prompted.