LXE hx3 参考指南
Cleaning the Ring Scanner Aperture
37
E-EQ-HX3RG-C
HX3 Reference Guide
Cleaning the Ring Scanner Aperture
Keep fingers and rough or sharp objects away from the ring scanner aperture. If the glass becomes
soiled or smudged, clean only with a standard household cleaner such as Windex® without
vinegar or use Isopropyl Alcohol. Do not use paper towels or harsh-chemical-based cleaning
fluids since they may result in damage to the glass surface. Use a clean, damp, lint-free cloth. Do
not scrub optical surfaces. If possible, clean only those areas which are soiled. Lint/particulates
can be removed with clean, filtered canned air.
soiled or smudged, clean only with a standard household cleaner such as Windex® without
vinegar or use Isopropyl Alcohol. Do not use paper towels or harsh-chemical-based cleaning
fluids since they may result in damage to the glass surface. Use a clean, damp, lint-free cloth. Do
not scrub optical surfaces. If possible, clean only those areas which are soiled. Lint/particulates
can be removed with clean, filtered canned air.
Strap Assemblies
Caution: Do not perform the following procedures if the ring barcode reader is tethered to the
HX3. There is a possibility the Scan button may be pressed inadvertently and the laser beam
emitted.
HX3. There is a possibility the Scan button may be pressed inadvertently and the laser beam
emitted.
LXE recommends that installation or removal of accessories be performed on a clean, well-lit
surface. When necessary, protect the work surface, the mobile device, and components from
electrostatic discharge.
surface. When necessary, protect the work surface, the mobile device, and components from
electrostatic discharge.
Note: Do not touch, push on or brace your finger against the scan aperture at any time.
Removing / Replacing the Ring Finger Strap Assembly
Note: Do not pull on the finger strap or the flexible liner to remove the finger strap assembly.
This quick disconnect function is designed for occasional safety hazards and is not
intended for daily removal.
intended for daily removal.
A 20 pak of Ring Scanner Finger Straps is available from LXE (8600A401RINGSTRAP). See
Accessories.
Accessories.
Using the Quick Disconnect Function, grasp the finger strap and pull the finger strap out and
away from the ring scanner.
away from the ring scanner.
Before attaching the finger strap to the trigger module, thread the finger strap, warning label side
down, first through the hinge, then under and over the pin next to the scan button.
down, first through the hinge, then under and over the pin next to the scan button.
It should slide easily.
Removing / Replacing the Trigger Module
Equipment Needed: Phillips screwdriver with a blade diameter of 1/8” (.4mm). Not supplied by
LXE.
LXE.
LXE recommends that installation or removal of accessories be performed on a clean, well-lit
surface. When necessary, protect the work surface, the mobile device, and components from
electrostatic discharge.
surface. When necessary, protect the work surface, the mobile device, and components from
electrostatic discharge.
A 20 pak of full Trigger assemblies is available from LXE (8600A403TRIGGERKIT). See
Accessories.
Accessories.