Netgear 14300289 用户手册

If all LEDs are still lit one minute after power-up, do the following:

Turn the power off and back on to see if the WiFi bridge/extender recovers.

To return the WiFi bridge/extender to its factory settings, press and hold the Reset button. 

If the error persists, you might have a hardware problem.

If one of the LAN port LEDs or the Internet LED does not light when the Ethernet connection 
is made, check the following:

Make sure that the Ethernet cable connections are secure at the WiFi bridge/extender 
and at the modem or computer.

Make sure that power is turned on to the connected cable MoCA modem or computer.

Be sure that you are using the correct cable.

When you connect the WiFi bridge/extender’s Internet port to a cable MoCA modem, use 
the cable that was supplied with the cable modem. 

If the WiFi LEDs stay off, check to see if the WiFi On/Off button on the WiFi bridge/extender 
has been pressed. This button turns the wireless radio in the WiFi bridge/extender on and off. 
The WiFi LEDs are lit when the wireless radio is turned on.

If, after you use the Push 'N' Connect (WPS) function, the WPS LED blinks green rapidly, 
check the following:

Make sure that you have used the WPS button on the front of the WiFi bridge/extender 
and not the WPS

 

Wizard on the Add WPS Client screen.

Check that PIN verification succeeded for the wireless device that you are adding to the 
wireless network.

Make sure that you have not pressed the WPS button on the front of the WiFi 
bridge/extender after disabling the WPS feature (you logged in to the WiFi 
bridge/extender and disabled this feature previously).

Check to see if the WiFi bridge/extender is stuck in the AP setup locked state (if you are 
using the wireless repeater function). To resolve this situation, either restart the WiFi 
bridge/extender, or do the following:

Select Advanced > Wireless Settings.

The Advanced Wireless Settings screen displays.

Select the Enable Router's PIN check box.