Ez Access Mobility Aid ez-access 用户手册

- 26 - 

12) 

 

A) 

The top support assembly provides supplemental support at the upper end of the 
ramp. When used, the top support assembly replaces the Ramp Handrail End 
Brackets. 

i) 

Attach top support brackets with two each 5/16” x 1½" bolts and two each 

5/16” flat washers. 
NOTE:

  There is a left and right top support bracket. The two 3/8” studs 

aligned horizontally should be toward the end of the ramp (FIG. 39). 

B) 

The following steps are done AFTER the ramp is resting on a supporting surface 
and the top transition plate is installed. IMPORTANT:  Read “INSTALLING A 
SINGLE RAMP” and “ANCHOR TOP TRANSITION PLATE” sections and ensure 
all steps are completed before proceeding with the steps that follow. 

i) 

Install support tube bracket on each top ramp support bracket using two 

each 3/8” nylock nuts into the threaded holes and two each 3/8” flat 
washers. DO NOT TIGHTEN (FIG. 40). 

ii) 

Install two each 3/8” x ½” hex bolts into the threaded holes on the support 

tube bracket. 

iii) 

Slide support tube into support tube bracket and onto base foot. 

iv) 

Level support tube and then tighten 3/8” nylock nuts to secure support tube 

bracket (FIG. 41). 

v) 

Adjust height as needed, and then tighten bolts. 

vi) 

Place end caps on support tube. 

 

 

 

FIG. 39 

FIG. 40 

FIG. 41 

- 7 - 

B) 

 

i) 

Place the surface of the platform face down, onto cardboard or a lawn so 
that the platform is not damaged (scratched or dented). 

ii) 

Each platform has two different configurations at each corner into which 
the platform saddle brackets and support legs can be installed. To account 
for obstacles, either position can be used as long as one platform saddle 
bracket is installed in each corner. 

iii) 

Position the platform saddle bracket over the threaded inserts located on 
each outside corner of the platform (FIG. 4). 

iv) 

Slide the platform saddle brackets into position (one end of the bracket will 
slide into the groove). NOTE:  If there are space limitations, the saddle 
brackets can be installed under the platform as shown in FIG. 7 (if 
necessary, support tubes can be cut to fit). 

v) 

Using a ½” socket wrench, attach a platform saddle bracket to the platform 
with two 5/16” x 1½” bolts and two 5/16” flat washers. 

 

(FIG. 5). Repeat this step for all four platform saddle brackets.  

  The 4 x 4, 5 x 4, and 5 x 5 platforms each use 4 (four) platform 

saddle brackets. 

vi) 

Once installed, start two each ⅜” x ½” bolts into the threaded holes in each 
platform saddle bracket (FIG. 6) in order to secure the support tube. 

 

FIG 7